Chevrolet 2010 Camaro Specifications download pdf (Page 69)

P/N: 4LGE020-010 v3.1, 2012-03-12

Fig 8H

Fig 8I

F. The supercharger should come to rest on the

pre-installed alignment guides which will pre-

vent the supercharger from moving forward or

backward. Once it is seated in this position,

insert the remaining of the ten (10) M6x1.0 x

75mm long screws (five (5) per side) and

start each of them through the manifold.

Once each screw has been started by hand,

torque all ten (10) M6 screws to 95-100 in/lbs

evenly in a criss cross pattern starting from

the center and going outward. See fig 8F,

8G, 8H.

G. Slide the OEM injector harness below the

injector connectors, as close to the manifold

as possible. Be sure to route the electrical

injector connectors under and out around the

harness to ensure that the connections have

adequate slack. See fig 8I.

Fig 8G

TUCK WIRING

HARNESS BELOW

INJECTOR

TERMINALS

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 100 101

No comments

Chevrolet 2010 Camaro Specifications Page 69