150. Carefully, set the supercharger assembly on
the engine, line up the bolt holes with the holes
in the cylinder heads. (Be careful of the one
bolt that under the rear supercharger pulley on
the passenger side as it protrudes and must be
aligned fi rst.)
151. Remove the black plastic sleeves that hold
some of the intake bolts up and start all ten intake
bolts by hand. Do not tighten until all the bolts
are started. (Be careful not to cross thread the
bolts.)
152. Torque the supercharger manifold bolts,
working from the center out to 89 In-Lbs. (10
Nm) using a 10mm socket and a inch pound
torque wrench.
149. Lay the plastic EVAP tube that ran from the
EVAP solenoid to the fi rewall along the side and
under the inlet of the supercharger manifold.
Bolt under pulley
2005-2007 C6 LS2 Corvette
Comments to this Manuals