APPLICATIONSINSTALLATION INSTRUCTIONS FOR PART 99-3303WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness:• IncludedAntenna Adapter: •
APLICACIONESINSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 99-3303• Destornillador Phillips • Llave de tubo • Destornillador de paleta • Cortador (solo C
1. Desenganche y retire las piezas de moldura de veta de madera/pintadas de ambos lados del volante. (Figura A)2. Desenganche y retire el panel lat
5. Desenganche y retire el panel lateral del lado del conductor del tablero con la puerta abierta y retire los (2) tornillos de 7 mm detrás del pane
Desmontaje del tablero 99-3303Pontiac G62005-20091. Abra la guantera y retire los (6) tornillos del borde exterior, luego desenganche y retire la gua
Desmontaje del tablero 99-3303Chevrolet Cobalt2005-20061. Desenganche y retire el panel de la moldura de arriba de la guantera. (Figura A)2. Deseng
Ensamble del kit 99-33031. Deslice la reja DIN en la carcasa del radio y sujétela doblando hacia abajo las pestañas de metal. (Figura A)2 Deslice l
Ensamble del kit 99-3303Provisión de unidad central ISO DIN1. Monte los soportes ISO en la unidad central con los tornillos incluidos con la unidad.
99-3303Ensamble del final A.B.C.D.1. Realizar las conexiones con Metra/EIA código de cableado tabla de, se muestra a continuación, y las instruccione
Modo de configuración y ajustesHay un modo de configuración y ajustes disponible para el ajuste individualizado del contraste, brillo y retroiluminaci
1. Unclip and remove wood grain/painted trim pieces from both sides of steering wheel. (Figure A)2. Unclip and remove side panel from driver’s side
5. Unclip and remove side panel from passenger side of dash with door open and remove (2) 7 mm screws from behind panel. (Figure E)6. Remove (2) 7
Dash Disassembly 99-3303Pontiac G62005-20091. Open glove box and remove (6) screws from outer edge then unclip and remove box. (Figure A)2. Remove
Dash Disassembly 99-3303Chevrolet Cobalt2005-20061. Unclip and remove trim panel from above glove box. (Figure A)2. Unclip upper edge of panel belo
Kit Assembly 99-33031. Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A)2 Slide the aftermark
Kit Assembly 99-3303ISO DIN head unit provision1. Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A)2. Slide
99-3303Final AssemblyA. Strip wire ends back 1/2”B. Twist ends togetherC. SolderD. TapeA.B.C.D.1. Make wiring connections using the Metra/EIA Wir
Final Assembly 99-3303Operation of the 99-3303Setting and Adjustment modeThere is a Settings and Adjustments mode available for the individualized adj
Comments to this Manuals