Chevrolet 2010 Impala Service Manual download pdf (Page 26)

REVISIONS MARKED IN BLUE 1/24/2011 2011 Chevrolet Municipal Vehicles Technical Manual

caPrIcE 9c1 aND 9c3 sPEcIaL EquIPmENt - oPtIoNaL | 15

Full-size spare tire is mounted under the load floor. The full-size spare tire includes

a Tire Pressure Monitor (TPM) sensor which must be programmed to the TPM

System after the spare tire is installed.

QQ5 FULL SIZE SPARE

Dome and courtesy lamps will not operate when doors are opened. Front

and rear dome lamps are controlled only by the switch at the front dome

lamp console.

7Y6 LAMP - INOPERATIVE DOME

HEADLAMPS

This option provides a flashing module, headlamp alternate high beam flashing, rear

alternate flashing of the stop and backup lamps and a control wire for connection a

customer furnished ON/OFF switch. A second control wire permits optional separate

control of headlamp flashing and rear lamps flashing via customer switching.

The headlamp flashing module is located at the right side of the underhood electrical

center. The headlamp flashing module is activated by application of 12-volts to a dark

green/red wire coiled in the right front footwell. When activated, the left and right

high beams and the high beam instrument cluster telltale will flash alternately at 2.4

flashes per second.

During daylight conditions, the Daytime Running Lights (DRL) are automatically

deactivated whenever the headlamp flasher module is activated; during nighttime

conditions, the low beams are automatically on while the high beams flash (unless

option VVS is present). Activating the high beam switch will override the flashing

mode and the high beams will operate continuously.

A 15-amp fuse (F16) protects the front flasher circuit and is located in the engine

wiring harness junction block at the right side of the engine compartment.

TAIL LAMPS AND BACKUP LAMPS

When the headlamp flashing module is activated the body control module will cause

the left and right stop lamps to flash alternately with the backup lamps at a rate of

2.4 flashes per second. The center high-mounted stoplamp does NOT flash and

operates only with application of the service brakes. During nighttime conditions, the

tail lamps are automatically ON (unless option VVS is present).

Activation of the headlamp and rear lamp flashing can be separated. Call Kerr

Industries at 905-725-6561 for instructions.

6J7 EXTERIOR LAMP EMERGENCY

FLASHING SYSTEM, HEADLAMPS,

TAIL LAMPS AND BACKUP LIGHTS

Two 4-inch, single faced, red and blue LED lamps are mounted to the deck lid inner

panel. Lamps are activated by the deck lid ajar mechanical switch when deck lid is

opened. Lamps are wired to flash alternately through a flasher located at the upper

right hand corner of the trunk opening. An optional switch is available from Kerr

Industries and is located at the right side of the deck lid to permit the flashing red/

blue lamps to be turned off.

Wiring is protected by fuse F8 in the rear fuse block located on top of the

standard battery in the trunk.

T53 LAMPS - TRUNK LID WARNING

1 ... 25 26 27 ... 182

Comments to this Manuals

No comments

Chevrolet 2010 Impala Service Manual Page 26

Comments to this Manuals

Related products and manuals for Cars Chevrolet 2010 Impala