Chevrolet 2011 Colorado User Manual download pdf (Page 156)

Black plate (10,1)

Chevrolet Colorado Owner Manual - 2011

7-10 Infotainment System

If the radio cannot find the desired

program type, NONE displays and

the radio returns to the last tuned

station.

SCAN: To scan PTYs, press and

hold the SEEK / SCAN until a beep

sounds. The radio goes to a station,

plays for a few seconds, then goes

to the next station.

BAND (Alternate Frequency):

Alternate frequency lets the radio

switch to a stronger station with

the same program type. To turn

alternate frequency on, press and

hold BAND for two seconds. AF ON

displays. The radio could switch to

stations with a stronger frequency.

To turn alternate frequency off,

press and hold BAND again for

2 seconds. AF OFF displays. The

radio does not switch to other

stations.

DISPL (Display): Press to change

what information displays while

using RDS. The display options

are station name, RDS station

frequency, PTY (program type),

and the name of the program

(if available).

Setting Preset PTYs Only

The six pushbuttons have factory

PTY presets. Up to 12 PTYs

(six FM1 and six FM2), can be

programmed on the numbered

pushbuttons. To program PTYs:

1. Press BAND to select FM1

or FM2.

2. Turn the P‐TYPE knob to

activate program type select

mode. TYPE and the last

selected PTY displays.

3. Turn the P‐TYPE knob to select

a PTY.

4. Press and hold one of the six

numbered pushbuttons until a

beep sounds. When that

numbered pushbutton is

pressed, the PTY that was

set, returns.

5. Repeat the steps for each

pushbutton.

Setting Preset Stations

If the radio does not have XM, up to

18 stations (six FM1, six FM2, and

six AM) can be programmed on the

six numbered pushbuttons.

If the radio has XM, up to

30 stations (six FM1, six FM2,

six AM, six XM1, and six XM2)

can be programmed on the six

numbered pushbuttons.

To program either radio:

1. Tune in the desired station.

2. Press and hold one of the six

numbered pushbuttons until the

radio beeps once. When that

numbered pushbutton is pressed

again, the station that was

stored, returns.

3. Repeat the steps for each

pushbutton.

1 ... 155 156 157 ... 394

Comments to this Manuals

No comments