Chevrolet ENCLAVE - NAVIGATION SYSTEM 2008 Specifications download pdf (Page 363)

The TPMS sensors can also be matched to each

tire/wheel position by increasing or decreasing the tire’s

air pressure. If increasing the tire’s air pressure, do

not exceed the maximum inﬂation pressure indicated

on the tire’s sidewall.

To decrease air-pressure out of a tire you can use the

pointed end of the valve cap, a pencil-style air pressure

gage, or a key.

You have two minutes to match the ﬁrst tire/wheel

position, and ﬁve minutes overall to match all four

tire/wheel positions. If it takes longer than two minutes, to

match the ﬁrst tire and wheel, or more than ﬁve minutes

to match all four tire and wheel positions the matching

process stops and you need to start over.

The TPMS sensor matching process is outlined below:

1. Set the parking brake.

2. Turn the ignition switch to ON/RUN with the

engine off.

3. Press the Remote Keyless Entry (RKE) transmitter’s

LOCK and UNLOCK buttons at the same time for

approximately ﬁve seconds. The horn sounds twice

to signal the receiver is in relearn mode and TIRE

LEARNING ACTIVE message displays on the DIC

screen.

4. Start with the driver side front tire.

5. Remove the valve cap from the valve cap stem.

Activate the TPMS sensor by increasing or

decreasing the tire’s air pressure for ﬁve seconds,

or until a horn chirp sounds. The horn chirp,

which may take up to 30 seconds to sound,

conﬁrms that the sensor identiﬁcation code has

been matched to this tire and wheel position.

6. Proceed to the passenger side front tire, and repeat

the procedure in Step 5.

7. Proceed to the passenger side rear tire, and repeat

the procedure in Step 5.

8. Proceed to the driver side rear tire, and repeat the

procedure in Step 5. The horn sounds two times

to indicate the sensor identiﬁcation code has been

matched to the driver side rear tire, and the

TPMS sensor matching process is no longer active.

The TIRE LEARNING ACTIVE message on the

DIC display screen goes off.

9. Turn the ignition switch to LOCK/OFF.

10. Set all four tires to the recommended air pressure

level as indicated on the Tire and Loading

Information label.

11. Put the valve caps back on the valve stems.

5-63

1 ... 362 363 364 ... 460

Comments to this Manuals

No comments

Chevrolet ENCLAVE - NAVIGATION SYSTEM 2008 Specifications Page 363

Comments to this Manuals

Related products and manuals for DVD players Chevrolet ENCLAVE - NAVIGATION SYSTEM 2008