Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Specifications Page 318

  • Download
  • Add to my manuals
  • Print
  • Page
    / 434
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 317
5. Check that the jumper cables do not have loose or
missing insulation. If they do, you could get a shock.
The vehicles could be damaged, too.
Before you connect the cables, here are some
basic things you should know. Positive (+) will go to
positive (+) or to a remote positive (+) terminal if
the vehicle has one. Negative () will go to a heavy,
unpainted metal engine part or to a remote
negative () terminal if the vehicle has one.
Do not connect positive (+) to negative () or you will
get a short that would damage the battery and maybe
other parts, too. And do not connect the negative ()
cable to the negative () terminal on the dead battery
because this can cause sparks.
6. Connect the red positive (+) cable to the positive (+)
terminal of the dead battery. Use a remote
positive (+) terminal if the vehicle has one.
7. Do not let the other end touch metal. Connect it to
the positive (+) terminal of the good battery. Use a
remote positive (+) terminal if the vehicle has one.
8. Now connect the black negative () cable to the
negative () terminal of the good battery. Use a
remote negative () terminal if the vehicle has one.
Do not let the other end touch anything until the next
step. The other end of the negative () cable does
not go to the dead battery. It goes to a heavy,
unpainted metal engine part or to a remote
negative () terminal on the vehicle with the dead
battery.
9. Connect the other end of the negative () cable at
least 18 inches (45 cm) away from the dead battery,
but not near engine parts that move. The electrical
connection is just as good there, and the chance
of sparks getting back to the battery is much less.
Your vehicle has a remote negative () terminal
for this purpose.
10. Now start the vehicle with the good battery and run
the engine for a while.
11. Press the unlock button on the remote keyless
entry transmitter to disarm your content
theft-deterrent system.
12. Try to start the vehicle that had the dead battery. If
it will not start after a few tries, it probably needs
service.
Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by your warranty. Always connect
and remove the jumper cables in the correct
order, making sure that the cables do not touch
each other or other metal.
5-42
Page view 317
1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 433 434

Comments to this Manuals

No comments