Chevrolet 2006 Colorado Specifications download pdf (Page 289)

100

101

Checking the Fluid Level

Prepare your vehicle as follows:

1. Park your vehicle on a level place. Keep the engine

running.

2. With the parking brake applied, place the shift lever

in PARK (P).

3. With your foot on the brake pedal, move the shift

lever through each gear range, pausing for about

three seconds in each range. Then, position

the shift lever in PARK (P).

4. Let the engine run at idle for three minutes or more.

Then, without shutting off the engine, follow these steps:

1. Flip the handle up and then pull out the dipstick

and wipe it with a clean rag or paper towel.

The automatic

transmission dipstick

handle with this symbol on

it is located in the engine

compartment on the

passenger’s side of the

vehicle.

See Engine Compartment Overview on page 5-12

for more information on location.

2. Push it back in all the way, wait three seconds and

then pull it back out again.

3. Check both sides of the dipstick, and read the lower

level. The ﬂuid level must be in the COLD area,

below the cross-hatched area, for a cold check or in

the HOT or cross-hatched area for a hot check.

Be sure to keep the dipstick pointed down to get an

accurate reading.

4. If the ﬂuid level is in the acceptable range, push the

dipstick back in all the way; then ﬂip the handle

down to lock the dipstick in place.

5-23

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 439 440

Comments to this Manuals

No comments

Chevrolet 2006 Colorado Specifications Page 289

Comments to this Manuals

Related products and manuals for Car alarm Chevrolet 2006 Colorado