Chevrolet 1999 Astro Specifications Page 114

  • Download
  • Add to my manuals
  • Print
  • Page
    / 386
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 113
Programming
the
HomeLink
Transmitter
Do
not use the HomeLink@ Transmitter with any garage
door opener that does not have the “stop and reverse”
feature. This includes any garage door opener model
manufactured before April
1,
1982.
Keep the original transmitter for use in other vehicles as
well as for future HomeLink@ programming. It is also
recommended that upon the sale of the vehicle, the
programmed HomeLink@ buttons should be erased for
security purposes. Refer to “Erasing HomeLink@ Buttons”
or, for assistance, contact HomeLinkO on the internet at:
www.home1ink.com or by calling 1-800-355-351 5.
Be sure that people and objects are clear of the
garage door or gate operator you are programming.
When programming a garage door, it is advised to park
outside of the garage.
It
is recommended that a new battery be installed in
your hand-held transmitter for quicker and more
accurate transmission of the radio frequency.
Your vehicle’s engine should be turned
off
while
programming the transmitter. Follow these steps
to
program up
to
three channels:
1.
Press and hold down the two outside buttons,
releasing only when the indicator light begins
to
flash, after
20
seconds.
Do
not hold down the
buttons for longer than
30
seconds and do not
repeat this step
to
program a second and/or third
transmitter to the remaining two HomeLink@ buttons.
2.
Position the end of your hand-held transmitter about
1
to 3 inches
(3
to 8 cm) away from the HomeLink@
buttons while keeping the indicator light in view.
3.
Simultaneously press and hold both the desired
button on HomeLink@ and the hand-held transmitter
button.
Do
not release the buttons until Step
4
has been completed.
Some entry gates and garage door openers may
require you to substitute Step 3 with the procedure
noted in “Gate Operator and Canadian
Programming’’ later in this section.
4.
The indicator light will flash slowly at first and then
rapidly after HomeLink@ successfully receives the
frequency signal from the hand-held transmitter.
Release both buttons.
2-35
Page view 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 385 386

Comments to this Manuals

No comments