Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Specifications download pdf (Page 343)

5. Remove the valve cap from the valve cap stem.

Activate the TPMS sensor by increasing or

decreasing the tire’s air pressure for ﬁve seconds,

or until a horn chirp sounds. The horn chirp,

which may take up to 30 seconds to sound,

conﬁrms that the sensor identiﬁcation code has

been matched to this tire and wheel position.

6. Proceed to the passenger side front tire, and repeat

the procedure in Step 5.

7. Proceed to the passenger side rear tire, and repeat

the procedure in Step 5.

8. Proceed to the driver side rear tire, and repeat the

procedure in Step 5. The horn sounds two times to

indicate the sensor identiﬁcation code has been

matched to the driver side rear tire, and the TPMS

sensor matching process is no longer active.

The TIRE LEARNING ACTIVE message on the DIC

display screen goes off.

9. Turn the ignition switch to LOCK/OFF.

10. Set all four tires to the recommended air pressure

level as indicated on the Tire and Loading

Information label.

11. Put the valve caps back on the valve stems.

Tire Inspection and Rotation

We recommend that you regularly inspect your

vehicle’s tires, including the spare tire, for signs of

wear or damage. See When It Is Time for New

Tires on page 5-69 for more information.

Tires should be rotated every 5,000 to 8,000 miles

(8 000 to 13 000 km). See Scheduled Maintenance

on page 6-4.

The purpose of a regular tire rotation is to achieve

a uniform wear for all tires on the vehicle. This

will ensure that your vehicle continues to perform

most like it did when the tires were new.

Any time you notice unusual wear, rotate the tires

as soon as possible and check wheel alignment.

Also check for damaged tires or wheels. See

When It Is Time for New Tires on page 5-69 and

Wheel Replacement on page 5-74.

5-67

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 433 434

No comments

Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Specifications Page 343