Chevrolet 2002 Malibu Owner's Manual download pdf (Page 99)

2-36

OFF: Move the lever to OFF to turn off the

windshield wipers.

INT (Intermittent): Move the lever to INT to choose a

delayed wiping cycle. Turn the INT ADJ band down for

a longer delay or up for a shorter delay. The further the

INT ADJ band is turned upward, the shorter the delay

will be and the further the INT ADJ band is turned

downward, the longer the delay will be. The wiper

speed can only be adjusted when the lever is in the

INT position. Use this position for light rain or snow.

LO (Low Speed): Move the lever up to the first

setting past INT, for steady wiping at low speed.

HI (High Speed): Move the lever up to the second

setting past INT, for wiping at high speed.

MIST: Move the lever all the way down to MIST for

a single wiping cycle. Hold it there until the windshield

wipers start; then let go. The windshield wipers will stop

after one wipe. If you want more wipes, hold the band

on mist longer.

Remember that damaged wiper blades may prevent

you from seeing well enough to drive safely. To avoid

damage, be sure to clear ice and snow from the wiper

blades before using them.

If they’re frozen to the windshield, carefully loosen

or thaw them. If your blades do become damaged,

get new blades or blade inserts.

Heavy snow or ice can overload your wiper motor.

A circuit breaker will stop the motor until it cools.

Clear away snow or ice to prevent an overload.

Windshield Washer

To wash your windshield, push in the button at the end

of the stalk until the washers begin.

CAUTION:

In freezing weather, don’t use your washer until

the windshield is warmed. Otherwise the washer

fluid can form ice on the windshield, blocking

your vision.

When you release the button, the washers will stop,

but the wipers will continue to wipe for about three

cycles and will either stop or will resume the speed

you were using before.

1 ... 98 99 100 ... 341

No comments

Chevrolet 2002 Malibu Owner's Manual Page 99