Chevrolet 2004 Tahoe Specifications download pdf (Page 403)

100

101

Checking the Fluid Level

Prepare your vehicle as follows:

• Park your vehicle on a level place. Keep the engine

running.

• With the parking brake applied, place the shift lever

in PARK (P).

• With your foot on the brake pedal, move the shift

lever through each gear range, pausing for about

three seconds in each range. Then, position the shift

lever in PARK (P).

• Let the engine run at idle for three minutes or more.

Then, without shutting off the engine, follow these steps:

The transmission dipstick

handle with the graphic is

located at the rear of

the engine compartment,

on the passenger’s side.

See Engine Compartment Overview on page 5-12 for

more information on location.

1. Flip the handle up and then pull out the dipstick

and wipe it with a clean rag or paper towel.

2. Push it back in all the way, wait three seconds and

then pull it back out again.

3. Check both sides of the dipstick, and read the lower

level. The ﬂuid level must be in the COLD area,

below the cross-hatched area, for a cold check or

in the HOT area or cross-hatched area for a

hot check. Be sure to keep the dipstick pointed

down to get an accurate reading.

4. If the ﬂuid level is in the acceptable range, push the

dipstick back in all the way; then ﬂip the handle

down to lock the dipstick in place.

5-25

1 2 ... 398 399 400 401 402 403 404 405 406 407 408 ... 547 548

Comments to this Manuals

No comments

Chevrolet 2004 Tahoe Specifications Page 403

Comments to this Manuals

Related products and manuals for Car alarm Chevrolet 2004 Tahoe