Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Specifications download pdf (Page 222)

5–8 EMERGENCIES

20. Wipe off any sealant from the wheel, tyre

or vehicle.

21. Dispose of the used sealant canister (5)

and sealant/air hose (7) assembly at a

local dealer or in accordance with local

regulations and practices.

22. Replace it with a new canister available

from your dealer.

23. After temporarily sealing a tyre using the

tyre sealant and compressor kit, take the

vehicle to an authorized dealer within a

161 km (100 miles) of driving to have the

tyre repaired or replaced.

12. Unplug the power plug (8) from the

accessory power outlet in the vehicle.

13. Turn the sealant/air hose (7) counterclock-

wise to remove it from the tyre valve stem.

14. Replace the tyre valve stem cap.

15. Replace the sealant/air hose (7), and the

power plug (8) back in their original

location.

16. If the flat tyre was able to inflate to the

recommended inflation pressure, remove

the maximum speed label from the seal-

ant canister (5) and place it in a highly

visible location.

Do not exceed the speed on this label until

the damaged tyre is repaired or replaced.

17. Return the equipment to its original

storage location in the vehicle.

18. Immediately drive the vehicle 8 km

(5 miles) to distribute the sealant in the

tyre.

19. Stop at a safe location and check the tyre

pressure. Refer to Steps 1 through 11 un-

der “Using the Tyre Sealant and Compres-

sor Kit without Sealant to Inflate a Tyre

(Not Punctured).”

If the tyre pressure has fallen more than

68 kPa (10 psi) below the recommended

inflation pressure, stop driving the vehicle.

The tyre is too severely damaged and the

tyre sealant cannot seal the tyre.

If the tyre pressure has not dropped more

than 68 kPa (10 psi) from the recom-

mended inflation pressure, inflate the tyre

to the recommended inflation pressure.

1 ... 221 222 223 ... 378

Comments to this Manuals

No comments