Chevrolet 2004 Blazer Specifications download pdf (Page 167)

DIC Operation and Displays

The DIC comes on when the ignition is on. After a short

delay the DIC will display the current driver and the

information that was last displayed before the engine

was turned off.

If a problem is detected, a warning message will appear

on the display. Pressing the trip stem will acknowledge

any warning or service messages. Pressing any of

the DIC steering wheel buttons (Trip Information, Fuel

Information, Personalization or Select button) will

also acknowledge any warnings or service messages.

The DIC has different modes which can be accessed by

pressing the four buttons on the DIC. These buttons

are trip information, fuel information, personalization and

select. The button functions are detailed following.

Trip Information

Use the trip information button to scroll through the

odometer, TRIP A, TRIP B and TIMER.

Odometer

Press the trip information button until the odometer

appears on the display. This shows the total distance

the vehicle has been driven in either miles or kilometers.

Pressing the reset stem located on the instrument

cluster with the vehicle off will also display the odometer.

Trip A and Trip B

Press the trip information button until TRIP A or TRIP B

is displayed. This shows the current distance traveled

since the last reset for each trip odometer in either miles

or kilometers. Both odometers can be used at the

same time.

Each trip odometer can be reset to zero separately by

pressing select while the desired trip odometer is

displayed. You can also reset the trip odometers with

the reset stem on the cluster. If you press and hold the

reset stem for four seconds, the display will show the

distance traveled since the last ignition cycle.

Timer

The DIC can be used as a stopwatch. Press the select

button while TIMER is displayed to start the timer.

The display will show the amount of time that has

passed since the timer was last reset (not including time

the ignition is off). Time will continue to be counted as

long as the ignition is on, even if another display is being

shown on the DIC. The timer will record up to 99 hours,

59 minutes and 59 seconds (99:59:59) after which

the display will roll back to zero.

To stop the counting of time, press the select button

brieﬂy while TIMER is displayed.

To reset the timer to zero, press and hold the select

button while TIMER is displayed.

3-49

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 449 450

Comments to this Manuals

No comments

Chevrolet 2004 Blazer Specifications Page 167

Comments to this Manuals

Related products and manuals for Car alarm Chevrolet 2004 Blazer