Chevrolet Silverado 2005 Specifications download pdf (Page 155)

100

101

Keep the original transmitter for use in other vehicles as

well as for future HomeLink

programming. It is also

recommended that upon the sale of the vehicle,

the programmed HomeLink

buttons should be erased

for security purposes. Refer to “Erasing HomeLink

Buttons” or, for assistance, contact HomeLink

the Internet at: www.homelink.com or by calling

1-800-355-3515.

Be sure that people and objects are clear of the garage

door or gate operator you are programming. When

programming a garage door, it is advised to park outside

of the garage.

It is recommended that a new battery be installed in

your hand-held transmitter for quicker and more

accurate transmission of the radio frequency.

Programming HomeLink

Your vehicle’s engine should be turned off while

programming the transmitter. Follow these steps to

program up to three channels:

1. Press and hold down the two outside buttons,

releasing only when the indicator light begins to

ﬂash, after 20 seconds. Do not hold down the

buttons for longer than 30 seconds and do not

repeat this step to program a second and/or third

transmitter to the remaining two HomeLink

buttons.

2. Position the end of your hand-held transmitter

about 1 to 3 inches (3 to 8 cm) away from the

HomeLink

buttons while keeping the indicator

light in view.

3. Simultaneously press and hold both the desired

button on HomeLink

and the hand-held transmitter

button. Do not release the buttons until Step 4

has been completed.

Some entry gates and garage door openers may

require you to substitute Step 3 with the procedure

noted in “Gate Operator and Canadian

Programming” later in this section.

4. The indicator light will ﬂash slowly at ﬁrst and then

rapidly after HomeLink

successfully receives the

frequency signal from the hand-held transmitter.

Release both buttons.

5. Press and hold the newly-trained HomeLink

button

and observe the indicator light.

If the indicator light stays on constantly,

programming is complete and your device should

activate when the HomeLink

button is pressed

and released.

To program the remaining two HomeLink

buttons,

begin with Step 2 under “Programming HomeLink

.”

Do not repeat Step 1 as this will erase all of the

programmed channels.

2-69

1 ... 154 155 156 ... 582

Comments to this Manuals

No comments

Chevrolet Silverado 2005 Specifications Page 155

Comments to this Manuals

Related products and manuals for Car alarm Chevrolet Silverado 2005