Chevrolet 2010 Equinox User Manual download pdf (Page 177)

Infotainment System 6-35

Infrared transmitters are on the

top of the left seatback video

screen. The headphones shut off

automatically to save the battery

power if the RSE system is shut

off or if the headphones are out of

range of the transmitters for more

than three minutes. Moving too

far forward or stepping out of the

vehicle, can cause the headphones

to lose the signal or have static.

The headphones may automatically

turn off after four hours of

continuous use.

To adjust the volume on the

headphones, use the volume

control.

For best audio performance, the

headphones must be worn correctly,

with the headband over the top of

the head. L (Left) and R (Right)

are above the ear pads and

are indicators as to how the

headphones should be placed on

the head.

Notice: Do not store the

headphones in heat or direct

sunlight. This could damage the

headphones and repairs will not

be covered by the warranty.

Storage in extreme cold can

weaken the batteries. Keep the

headphones stored in a cool, dry

place.

If the foam ear pads become worn

or damaged, they can be replaced

separately from the headphones.

See your dealer/retailer for more

information.

Battery Replacement

To change the batteries:

1. Loosen the screw to the battery

door located on the left side of

the headphones.

2. Slide the battery door open.

3. Replace the two AAA batteries.

4. Replace the battery door and

tighten the screw.

Remove the batteries if the

headphones are not going to be

used for a long period of time.

Audio/Video (A/V) Jacks

If available, the A/V jacks are

located on the rear of the floor

console. They allow audio or video

cables to be connected from an

auxiliary device such as a

camcorder or a video game system.

The A/V jacks are color coded:

.

Yellow for video input.

.

White for left audio input.

.

Red for right audio input.

Power for auxiliary devices is not

supplied by the radio system.

To use the auxiliary inputs of the

RSE system:

1. Connect the auxiliary device

cables to the A/V jacks.

2. Power on both the auxiliary

device and the RSE video

screen.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 409 410

Comments to this Manuals

No comments