Chevrolet 2012 Equinox User Manual download pdf (Page 46)

Black plate (12,1)

Chevrolet Equinox Owner Manual - 2012

2-12 Keys, Doors, and Windows

Pressing any button, or the

touchpad switch, while the liftgate is

moving stops it. Pressing the button

or RKE switch again reverses the

direction. The touchpad switch will

stop the liftgate from moving. There

is a minimum distance that the

power liftgate must already be open

for the system to hold it open.

If movement is stopped below that

minimum, the liftgate closes.

Do not force the liftgate open or

closed during a power cycle.

The power liftgate may be

temporarily disabled under extreme

temperatures or low battery

conditions. If this occurs, the liftgate

can still be operated manually.

If you shift the transmission out of

P (Park) while the power function is

in progress, the liftgate power

function will continue to completion.

If you shift the transmission out of

P (Park) and accelerate before the

power liftgate latch is closed, the

liftgate may reverse to the open

position. Cargo could fall out of the

vehicle. Always make sure the

power liftgate is closed and latched

before you drive away.

If you power open the liftgate and

the liftgate support struts have lost

pressure, the turn signals flash and

a chime sounds. The liftgate stays

open temporarily, then slowly

closes. See your dealer for service

before using the liftgate.

Obstacle Detection Features

If the liftgate encounters an obstacle

during a power open or close cycle,

a warning chime will sound and the

liftgate will automatically reverse

direction to the full closed or open

position. After removing the

obstruction, the power liftgate

operation can be used again. If the

liftgate encounters multiple

obstacles on the same power cycle,

the power function will deactivate.

The MANUALLY CLOSE POWER

LIFTGATE warning message in the

Driver Information Center (DIC) will

display. After removing the

obstructions, the liftgate will resume

normal power operation.

Pinch sensors are located on the

side edges of the liftgate. If an

object is caught between the liftgate

and the body and presses against

this sensor, the liftgate will reverse

direction and open fully. The liftgate

will remain open until it is activated

again or closed manually.

Power Liftgate 3/4 Mode

To program the liftgate opening

height:

1. Turn the liftgate switch to either

the MAX, or the 3/4 mode

position and power open the

liftgate.

2. Stop the liftgate movement at

the desired height by pressing

any liftgate switch. Manually

adjust the liftgate position if

required.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 427 428

Comments to this Manuals

No comments