
AM-FM
Stereo with Cassette Tape
Player
and
Automatic
Tone
Control
(If
Equipped)
Playing
the
Radio
PWR-VOL:
Press this knob to turn the system on and
off.
To
increase volume, turn the knob clockwise. Turn
it
counterclockwise
to
decrease volume. The faster the
PWR-VOL knob is rotated, the quicker the radio goes to
maximum. The knob is capable of rotating continuously.
RECALL: Display the time with the ignition off by
pressing this button. When the radio is playing, press
this button to recall station frequency.
SCV
Your system has a feature called
Speed-Compensated-Volume (SCV). With SCV, your
audio system adjusts automatically to make up for road
and wind noise as you drive. Set the volume at the
desired level. Move the control ring behind the upper
knob clockwise to adjust the SCV. Then, as you drive,
SCV
automatically increases the volume, as necessary,
to overcome noise at
any
particular speed. The volume
level should always sound the
same
to you
as
you drive.
If
you don’t want to use
SCV,
turn the control all the
way down. Each detent on the control ring allows for
more volume compensation at a faster rate
of
speed.
Finding a Station
AM-FM:
Press this button to switch between
AM,
FMI
and
FM2.
The display shows your selection.
TUNE: Press this knob lightly
so
it extends.
Turn
it to
choose radio stations.
Push
the knob back into its stored
position when you’re not using it.
SEEK:
Press the right or left
arrow
to
go
to the next higher
or lower station. The sound will mute while seeking.
SCAN: Press and hold
SEEK
for two seconds until
SCAN
appears on the display. SCAN allows you
to
listen to each station for a few seconds. The radio will
go to a station, stop for a few seconds, then go on
to
the
next station. Press
SEEK
again to stop scanning. The
sound will mute while scanning.
3-13
Comments to this Manuals