Chevrolet SSR 2004 Installation Manual download pdf (Page 17)

5.4 Disconnect the positive (+) battery

cable from the back of the alternator with a

10mm wrench. Use a 15mm socket wrench

remove the two bolts holding the alternator

to the alternator bracket and then remove

the alternator.

56. For clarity this mount is shown

removed from the engine. Using a marking

pen and a straight edge, mark a line as

shown on the top surface of the of the

alternator mount. Start the line at the left

(driver’s) rear corner of the idler mount and

then to the right rear corner of the alternator

mount. Continue the line at an angle for a

distance of about 1-1/4” to the back edge of

the casting behind the alternator mount.

Using a suitable grinder and eye protection,

remove the material up to the line.

55. It will be necessary to make clearance

on the alternator mount casting for the new

manifold to fit properly. The new manifold

should not touch the alternator mount.

These modifications can be easily done

with the mount in place.

Remove this

material

5.3 Disconnect the positive ( ) battery

cable from the back of the alternator with a

10mm wrench.

7/12

Page 17

2003-2004 Chevy SSR Supercharger Installation Instructions

magnacharger.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

No comments

Chevrolet SSR 2004 Installation Manual Page 17