Chevrolet 2006 Tahoe Specifications download pdf (Page 103)

To enter the program mode, do the following:

1. Begin with the ignition off. Then pull the turn

signal/multifunction lever toward you and hold

it there while you perform the next step.

2. Turn the key to RUN and LOCK twice. Then,

with the key in LOCK, release the turn signal/

multifunction lever. Once you do this, you will hear

the lock switch lock and unlock, the horn will

chirp twice, and a 30 second program timer will

begin. You are now ready to program the automatic

door locks.

3. Select one of the two programming options listed

previously, and press the lock side of the power door

lock switch to cycle through the lock options. You will

have 30 seconds to begin programming. If you

exceed the 30 second limit, the locks will

automatically lock and unlock and the horn will chirp

twice to indicate that you have left the program

mode. If this occurs, repeat the procedure beginning

with Step 1 to re-enter the programming mode.

You can exit the program mode any time by turning the

ignition to RUN (the locks will automatically lock and

unlock and the horn will chirp twice to indicate that you

are leaving the program mode). If the lock/unlock

switches are not pressed while in the programming

mode, the current auto lock/unlock setting will not

be modiﬁed.

See your dealer for more information.

Programmable Unlocking Feature

The following is the list of available programming

options:

Mode 1: Driver’s door unlocks when the transmission is

shifted into PARK (P).

Mode 2: All doors unlock when the transmission is

shifted into PARK (P).

Mode 3: All doors unlock when the key is removed

from the ignition.

Mode 4: No automatic door unlock.

The automatic door locks were pre-programmed at the

factory to unlock the driver’s door once the transmission

is shifted to PARK (P). The following instructions detail

how to program your door locks differently than the

factory setting. Choose one of the four programming

options listed above before entering the program mode.

To enter the program mode, do the following:

1. Begin with the ignition off. Then pull the turn

signal/multifunction lever toward you and hold

it there while you perform the next step.

2. Turn the key to RUN and LOCK twice. Then, with the

key in LOCK, release the turn signal/multifunction

lever. Once you do this, you will hear the lock switch

lock and unlock, the horn will chirp twice, and a

30-second program timer will begin.

2-11

1 ... 102 103 104 ... 536

Comments to this Manuals

No comments

Chevrolet 2006 Tahoe Specifications Page 103

Comments to this Manuals

Related products and manuals for Cars Chevrolet 2006 Tahoe