Chevrolet 2010 Equinox User Manual Page 258

  • Download
  • Add to my manuals
  • Print
  • Page
    / 410
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 257
8-44 Driving and Operating
Cruise Control
With cruise control, the vehicle can
maintain a speed of about 40 km/h
(25 mph) or more without keeping
your foot on the accelerator. Cruise
control does not work at speeds
below 40 km/h (25 mph).
If the brakes are applied, the cruise
control shuts off.
If the vehicle has the StabiliTrak
®
or traction control system and
begins to limit wheel spin while
using cruise control, the cruise
control automatically disengages.
See StabiliTrak System
on
page 843
or Traction Control
System (TCS)
on page 841
. When
road conditions allow you to safely
use it again, the cruise control can
be turned back on.
{
WARNING
Cruise control can be dangerous
where you cannot drive safely at
a steady speed. So, do not use
the cruise control on winding
roads or in heavy traffic.
Cruise control can be dangerous
on slippery roads. On such roads,
fast changes in tire traction can
cause excessive wheel slip, and
you could lose control. Do not use
cruise control on slippery roads.
Setting Cruise Control
{
WARNING
If you leave your cruise control on
when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
You could be startled and even
lose control. Keep the cruise
control switch off until you want to
use cruise control.
The cruise control buttons are
located on the steering wheel.
5 (On/Off): Press to turn the
cruise control system on and off.
\ (Cancel): Press to cancel cruise
control without erasing the set
speed from memory.
RES/+ (Resume/Accel): Move the
thumbwheel up to resume a set
speed or to accelerate to a higher
speed.
SET/ (Set/Coast): Move the
thumbwheel down toward SET/ to
set a speed and activate cruise
control or to decrease the speed.
Page view 257
1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 409 410

Comments to this Manuals

No comments