Chevrolet 2010 Equinox User Manual Page 262

  • Download
  • Add to my manuals
  • Print
  • Page
    / 410
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 261
8-48 Driving and Operating
The following describes how the URPA display lights appear as the vehicle
gets closer to a detected object:
Description Metric English
amber light 2.5 m 8 ft
amber/amber lights 1.0 m 40 in
amber/amber/red lights and
continuous beeping for
five seconds
0.6 m 23 in
amber/amber/red lights flashing
and continuous beeping for
five seconds
0.3 m 1 ft
Park Assist Off displays on the
Driver Information Center (DIC) to
indicate that URPA is off, see Driver
Information Center (DIC)
on
page 427
for more information.
System Settings
Each time the vehicle is started
URPA defaults to the On setting.
Use the Vehicle Personalization
on
page 439
menu to
configure URPA.
The settings are:
.
On: Turns URPA on
.
Off: Turns URPA off
.
Tow Bar: Use when a tow bar is
attached to the vehicle
Tow Bar
When the tow bar setting is used,
an area of 16 cm (6 in) around the
hitch is not detected by the system.
When the System Does Not
Seem to Work Properly
If the URPA system does not
activate due to a temporary
condition, the message Park Assist
Off displays on the DIC and a red
light is shown on the rear URPA
display when the shift lever is
moved into R (Reverse). This can
occur under the following
conditions:
.
The ultrasonic sensors are not
clean. Keep the vehicle's rear
bumper free of mud, dirt, snow,
ice and slush. For cleaning
instructions, see Exterior Care
on page 981
.
.
A trailer was attached to the
vehicle, or an object was
hanging out of the liftgate during
the last drive cycle, a red light
may come on in the rear display.
Once the attached object is
removed, URPA will return to
normal operation.
Page view 261
1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 409 410

Comments to this Manuals

No comments